Assembly Part 2

In this part, you will assemble the chassis frame for the Robot. The parts you will need for this step are the three sub-assemblies from the previous step and hardware from Bag Two of your kit. You will also need a small phillips head screwdriver.

Step 1

Position the three sub-assemblies from step one on the table in a hexagonal shape like this:

Step 2

Bolt these three pieces together. Start with the screw through each aluminum piece, then the washer, and finish with the hex nut. Don't tighten these yet, just put them together. You will tighten them later, after the servos have been installed.

Detail of sub-assembly bolting.

Continue on to the next building step .

Review the previous building step .

PPRK
Resources

Overview
Assembly
Downloads