| Hardware Reset (GP 1.0) | Index |
It is possible to corrupt the system settings in a BrainStem module with erroneous commands. When this occurs, it may no longer be possible to communicate with the module through the serial link, or through the IIC link if it is in a network. To regain control of the BrainStem module, it is necessary to perform a hardware reset by connecting a jumper resistor between two pins on the GP 1.0 board and turning the power on and off. The steps for doing this are as follows:
1. Turn off power to the module.
2. Disconnect the serial cable from the module (if attached). Disconnect the module from the IIC bus (if attached).
3a. If your module is a GP 1.0 module with a build number of 8 or lower (ID on back of board is 00000211 or lower), connect a 1K-10K Ohm resistor between the STX and SRX pins of the module's serial port.
3b. Otherwise, connect a 1K-10K Ohm resistor between the SRX pin of the module's serial port and the SDA pin of the module's IIC port.
4. Reapply power. The green LED on the module will blink rapidly for a moment, turn off briefly, then continue to blink rapidly. This indicates a successful hardware reset.
5. Turn off power to the module.
This procedure will not alter any stored TEA programs or reflexes. After a hardware reset, the BrainStem GP 1.0 module will have the following default system settings:
| ParamID | Description | VALUE |
| 0 | Module IIC Address | 2 |
| 1 | Router IIC Address | 2 |
| 2 | Heartbeat Rate | 10 (256 ms) |
| 3 | IIC Baud Rate | 2 = 1 Mbps |
| 4 | Serial Baud Rate | 2 = 9600 |
| 5 | Heartbeat Mode | 0 = Link |
| 6 | Boot Reflex Flag | 0 = No Reflex at Power-up |
| 7 | Link Reflex Flag | 0 = No Reflex at link-down |
| 15 | VM Boot File 1 | 255 = no file |
| 16 | VM Boot File 2 | 255 = no file |
| 17 | VM Boot File 3 | 255 = no file |
| 18 | VM Boot File 4 | 255 = no file |
| 19* | Serial Relay Flag | 0 = disabled |
| 20* | Quiet Mode Flag | 0 = disabled |
| 21* | Serial Timeout | 40 = timeout of 1024ms |
* This feature is only available in new BrainStem modules or BrainStem GP 1.0 modules with firmware Build 9 or higer.
The servo outputs will also be reset. Each servo will be enabled and centered at position 128. Each servo will have a 90 degree range. This 90 degree range will be centered within the 180 degree range of a typical servo.
Connect the BrainStem module via the serial cable to your computer and re-apply power. Use the Console program to reconfigure the system parameters to the appropriate settings for your application.